Installation Instructions for 11005, 11006, 11007 & 11008 Ignition Panel, 2-1/2” x 6-1/4”

Installation Instructions: 

1. Using the panel as a template, mark the location of the four mounting holes. 

2. Carefully drill four holes in the locations you marked using a 13/64” drill bit. 

3. Install four(4) supplied flat head screws, washers & lock nuts. 

4. Tighten and secure the panel in place. 

If you have purchased part #555-11006 (standard toggle kit) or #555-11007 (lighted toggle kit), please continue the following steps: 

5. Slide the toggle switches through the 1/2” holes from behind. Be sure the keyway in the switch is facing down. 

6. Tighten down using the toggle switch nut or bezel. 

Ignition panel components can be purchased separately from JEG’S:  

20 AMP toggle switch…………………#555-11020 

Lighted toggle switch………………….#555-11022 

LED indicator lamp……………………#555-11024 

Toggle switch cover…………………..#555-11025